System Setup
9 - 308
6. Press [ENTER] of the PP again, and select {YES}. The data is updated.
7. After updating the data, select {FILE} - {INITIALIZE} - “Safety Board FLASH Reset”, and
select {YES}.
At the sound of the beep, the re-setting is completed and the message on the PP
disappears.
8. Turn the YRC1000 power OFF and then ON again.
9. Select {SYSTEM} {SECURITY}, and change the SECURITY mode to the SAFETY
mode.
10. Select {SAFETY FUNC.} {SAFETY LOGIC CIRCUIT}.
The following window appears and the setting of the safety logic circuit can be
performed.
To Next Page
Loading...
