YOKOGAWA CENTUM CS 3000 - Page 178

3. Cabling
3-100
TI 33Q01J10-01E
How to wiring ER bus
The figure shown below describes how to wiring ER bus:
F030813.ai
Connect to the
next ER bus node unit
Fix with using a cable fastener
at the front right edge of cable tray.
Separate from other cables as much as possible.
EB401
Terminator
(YCB148)
Clamp filter
(A1193MN)
Fix with using a cable fastener
at the front right edge of cable tray.
YCB141
Separate from other cables.
Adjust the cable length
on the cable tray if required.
EB501
ANB10D
ANR10D
Figure How to wiring ER bus
May 18, 2007-00