v
TI 33J01J10-01EN
Mar. 29, 2019-00
l
l Standards for Hazardous Location Equipment [ATEX Typei and IECEx were
added]
n
[Electric
1.6 Cabling Requirements
n Ambient Temperature [A2BN5D was added]
2. Transportation, Storage and Installation
2.5 Installation
3. Cabling
3.1 Cables and Terminals [A2BN5D was added] [n Bending radius of cable was added]
n
n Power Cables [Barrier for Base Plates were added][Value was corrected]
n Grounding Cables [Barrier Base Plates were added]
3.2 Connecting Power
n
3.4 Power and Ground Cabling [A2BN5D was added]
n A2NN30D Node Interface Unit
screw was corrected] [A2BN5D was added]
n A2BN3D Base Plate for Adaptor [The caption was added]
n A2BN4D Base Plate for Barrier [The cable length restriction was added]
n
[A Screw size of NIU was corrected] [Important information was added]
n
of NIU was added]
3.5 Connecting Signal Cable
n
l Pressure Clamp Terminal, Spring Clamp Terminal (for N-IO Node)
Table Applicable Interface [A2BN5D was added]
n Connecting Signal Cables to Terminals (for N-IO)
corrected
n
l
added]
3.7.2 Base Plate for Adaptor
n
Table Terminal Numbers and Signal Types (A2BN3D) [An error of A2SDV506
was corrected]
3.7.4 Base Plate for Barrier [A2BN5D was added]
3.8 Connecting Bus Cable
n
n
n
To Next Page
Loading...
Need help?
General
