ADCMT 6166 User Manual

6166 DC Voltage Current Source Operation Manual
3.6 Changing Range
3-21
The following is an example to select 100 mV range of the divider voltage function and set the source
value to +100 mV.
Press .
The 100 mV range of the divider voltage function is selected and the source value is set to +100 mV.
Example display
NOTE: If the source function is switched in Operate status, the output status will be set to Standby.
(4) Changing to the thermal electromotive force function
For information on how to set the thermal electromotive function, refer to Section 3.10.1, "Setting
Thermal Electromotive Force Function."
3.6 Changing Range
This section describes the procedure of setting the range of the voltage function.
Operating procedure
Check that the program function is set to OFF.
When the program function is set to ON, the PROGRAM key lights up. Pressing the PROGRAM
key sets it to OFF.
Press to select auto range once.
When auto range is selected, the AUTO key lights up.
4
1 2 354 68 7
1
2

ADCMT 6166 Specifications

General

Brand	ADCMT
Model	6166
Category	Measuring Instruments
Language	English