Appendix C Color Coding of Indicator Lights
Adept MV Controller User’s Guide, Rev. B 231
Color Coding of Indicator Lights
Adept uses colored lamps and indicators to indicate equipment status. There are
two categories of indicator:
• Operator indicators. These are located on the exterior of the equipment and
form part of the operator interface, specifically, the Manual Control Pendant
(MCP), Compact Interface Panel (CIP), and the graphics monitor. The colors
Yellow, Green, White, and Orange are used.
• Service indicators. These are located on the front panels of the controller VME
boards, and on the amplifier front panels. When the Adept controller is
installed as instructed (inside a recommended enclosure), these indicators are
not visible to the operator.
Color Code Used by Adept for Operator Indicators
Table C-3. Operator Indicator Color Code
.#) #7-
I'')3
#7 &)##) E##7 #)8
) .##)J #- )') #- - ) ))N- #)8
#) )#)#7 2) #$#)8 )) -)' )-$ #)
-- 5# # )#) 5) ##)8
/# 7
#7 '8
) .##)J - )')- - ) )$# 7' #5)#)8
#) )#)#7J #- )5 ##) --#-- )) # )#)#7 E#
--8
.''# )-
6
#7 )' )#)8
) .##) ) &)5##)J #- )') #- - ) ))N- #)
2) 5) )5##)8
#) .#- --8 '-) E# )) #)8 , -#5# )#) 5)
)8
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General