adept technology MV User Manual

Chapter 7 Camera Cable Pin and Signal Information
Adept MV Controller User’s Guide, Rev. B 155
Camera Cable Pin and Signal Information
This section provides the pin and signal information for the connectors and cables
associated with the AdeptVision product.
• Table 7-7 describes the Hirose connector that is used for all cameras except
the Pulnix TM-1001 on the camera breakout cables.
• Table 7-8 describes the Hirose connector that is used for the Pulnix TM-1001
on the custom four-camera breakout cable.
• Table 7-9 describes the Strobe and Power connector on the Pulnix TM-1001
camera cables.
• Table 7-10 describes the 10-meter camera extension cable.
• Table 7-11 describes signal information between the 44-pin connector and the
camera and strobe/power connectors for the four-camera breakout cable. The
table is organized by camera number.
• Table 7-12 describes signal information between the 44-pin connector and the
camera and strobe/power connectors for the Pulnix TM-1001 custom
four-camera breakout cable. The table is organized by camera number.
• Table 7-13 contains information similar to Table 7-11, but it is organized
numerically by the 44-pin connector.
• Table 7-14 contains information similar to Table 7-12, but it is organized
numerically by the 44-pin connector.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

adept technology MV Specifications

General

Brand	adept technology
Model	MV
Category	Controller
Language	English