Chapter 1 Standards Compliance
Adept MV Controller User’s Guide, Rev. B 33
Standards Compliance
The Adept controller is intended for use with other equipment and is considered
a subassembly rather than a complete piece of equipment on its own. The Adept
controller meets the requirements of EN 60204, EN 61131-2, IEC 204, IEC 1131-2,
IEC 73, and IEC 447 safety standards. See the Declaration of Conformity (inside
front cover of this manual) for additional compliance information about this
product.
To maintain compliance with the above standards, the controller must be installed
and used properly with any additional equipment, in accordance with all
regulations of the standards. You must also carefully follow all installation
instructions in this user guide.
See for additional information on standards compliance.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General