adept technology MV - MCP Predefined Functions; Introduction; Predefined Function Buttons; The Edit Function

Appendix D MCP Predefined Functions
Adept MV Controller User’s Guide, Rev. B 241
MCP Predefined Functions
Introduction
This section describes the manual control pendant functions related to:
• Loading and starting programs
• Editing global variables
• Displaying system status
Predefined Function Buttons
The .% has five predefined function buttons for your use. They are listed and
explained below.
Figure D-5. MCP Predefined Function Buttons
The Edit Function
The Edit function button allows editing of location variables and real variables
that are used by V
+
programs.
EDIT DISP
CLR
ERR
CMD
PROG
SET
WORLD TOOL JOINT FREE DEV
USER
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com