!"
97
that are allocated by the programs; or use the STACK monitor com-
mand to increase the size of the stack for the program task. The pro-
gram may be restarted with the RETRY command.
*Not enough prototype storage area* (–717)
Explanation: The vision system does not have enough memory to store all of the
prototypes requested.
User action: VDELETE unused prototypes, load fewer prototypes, or use simpler
object models.
*Not enough storage area* (–411)
Explanation: There is no more space in RAM for programs or variables.
User action: Delete unused programs and variables. If the memory is frag-
mented because of numerous deletions, it can be consolidated by
issuing the commands STORE save_all, ZERO, and LOAD save_all.
This writes the memory contents to the disk and reads them back
into memory. Note, however, that this procedure does not retain any
variables that are not referenced by any program in memory, nor
does it retain the values of variables that are defined to be AUTO or
LOCAL.
*Not found* (–356)
Explanation: The search operation was unable to locate the specified string.
User action: Enter a new search string, or consider this an informational message
and continue with other operations.
*Not owner* (–566)
Explanation: The client does not have the correct access identity to perform the
requested NFS operation.
User action: Modify the LOCAL_ID statement in the V
+
configuration file (using
the CONFIG_C utility) as required to gain access to the server. You
may also need to change the access setup on the server itself.
*NVRAM battery failure* (–665)
Explanation: The nonvolatile RAM battery backup has failed and the RAM may
not hold valid data.
User action: Replace NVRAM battery.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General