!"
/7
User action: See the general comments above. If the problem persists, contact
Adept Customer Service and provide the exact details of the error
message.
*Vision not calibrated* (–713)
Explanation: A vision command was entered that required the vision system to
be calibrated, and the vision system is not calibrated.
User action: Calibrate the vision system or load calibration data from a disk file.
*VISION not enabled* (–701)
Explanation: A vision command was entered before the vision system has been
enabled.
User action: Enter an ENABLE VISION command and retry the previous com-
mand.
*Vision option not installed* (–720)
Explanation: During initialization, the V
+
system failed to detect the presence of
the vision processor. No vision instructions or commands will be
accepted. Otherwise, V
+
will operate normally.
User action: Check to make sure that the vision processor is installed and that
your software supports vision. Power down the controller and
restart. If the problem persists, contact Adept Customer Service.
*Vision software incompatible* (–762)
Explanation: There is an incompatibility between the versions of vision and V
+
software running on your controller. It indicates that the system
software you have loaded has been built incorrectly and is likely to
crash. This message should never be seen.
User action: Do not use this system software. Reload your system software with
a known good version. Report this problem to Adept Customer Ser-
vice.
*Vision system out of memory* (–733)
Explanation: The vision system has run out of free memory for the last operation
attempted. This message should not be confused with *[Vision
error] Out of memory*. This error does not disable the vision switch
and is always returned in direct response to the last vision instruc-
tion.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General