#!
79
–318 *Program task not active*
–319 *Program task not in use*
–350 *Can’t delete .PROGRAM statement*
–351 *First statement must be .PROGRAM*
–352 *Invalid in read-only mode*
–353 *No other program referenced*
–354 *Line too long*
–355 *Can’t exit while lines attached*
–356 *Not found*
–357 *Recursive macros illegal*
–358 *Cancelled*
–359 *Illegal in debug monitor mode*
–360 *Must be in debug mode*
–361 *Can’t change modes while task running*
–362 *Can’t execute from SEE program instruction*
–363 *Unknown editor command*
–364 *Can’t create program in read-only mode*
–365 *Illegal in read-write mode*
–366 *Invalid when program on stack*
–380 *Breakpoint not allowed here*
–400 Aborted
–401 *Undefined value*
–402 *Illegal value*
–403 *Illegal assignment*
–404 *Illegal array index*
–405 *Illegal digital signal*
–406 *Undefined program or variable name*
–407 *Invalid argument*
Table E-7. Error Messages (Continued)
Code Message Text
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General