#!
71
54 *Warning* SET.SPEED switch disabled
55 *Warning* Monitoring watchpoint
56 *Warning* Watchdog timer disabled
57 Press HIGH POWER button to enable power
58 Push, release, hold MCP enable switch
60 Press HIGH POWER button when blinking
100 Network connection opened
101 Network connection closed
Table E-7. Error Messages
Code Message Text
–300 *Illegal monitor command*
–301 *No program specified*
–302 *DO not primed*
–303 *Controller not in automatic mode*
–304 *Controller not in manual mode*
–305 *Storage area format error*
–307 *Program not executable*
–308 *Program interlocked*
–309 *Program already exists*
–310 *Can’t access protected or read-only program*
–311 *Invalid when program task active*
–312 *Can’t start while program running*
–313 *Can’t go on, use EXECUTE or PRIME*
–314 *Switch can’t be enabled*
–315 *Invalid software configuration*
–316 *Software checksum error*
–317 *Controller not in network mode*
Table E-6. Warning Messages (Continued)
Code Message Text
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
