Chapter 4 AWC Module Serial I/O Ports
84 Adept MV Controller User’s Guide, Rev. B
To change the configuration of the RS-422/485 port, use the CONFIG_C utility
program or the V
+
FSET program instruction. This port is designated
LOCAL.SERIAL:1.
Table 4-9. RS-422/485 Connector Pin Assignments
Pin Signal Type
1GND Ground
2GND Ground
3TXD- Output
4RXD+ Input
5TXD+ Output
6RXD– Input
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
