Rockwell Automation Publication 5069-UM002A-EN-P - January 2019 111
Use the Secure Digital Card Chapter 4
2. On the Nonvolatile Memory tab, verify that the project that is listed is
the correct one.
3. Click Load/Store.
TIP If no project is stored on the SD card, a message on the Nonvolatile Memory
tab indicates that an image (or project) is not available.
TIP If Load/Store is dimmed (unavailable), verify the following:
• You have specified the correct communication path and are online with
the controller.
• The SD card is installed.
• Verify that the controller is not in Run Mode.
To Next Page
Loading...
