Rockwell Automation Publication 5069-UM002A-EN-P - January 2019 239
Commercial Operating System Chapter 10
9. When a confirmation dialog box appears, click Yes.
10. Before the firmware update begins, this dialog box appears. Take the
required action for your application. In this example, the upgrade
continues when OK is clicked.
The final part of the process is an automatic power cycle on
the controller.
11. When the Update Status dialog box indicates that the update is
complete, click OK.
12. Close the ControlFLASH software.
13. Complete the steps described in
Use the Operating System Utilities Tool
to Reinstall the COS on page 231.
IMPORTANT A Progress dialog box appears that does not indicate that any
activity is occurring. This is normal operation. Do not take action.
The next dialog box appears approximately a minute later.
IMPORTANT Do not interrupt the update process until it is complete. If the process is
interrupted, you must repeat the entire process, beginning at
step 2 on
page 236.
To Next Page
Loading...
Need help?
General
