Engine Service 9960 Self-Propelled Peanut Combine
148 06/03/05 MAN091
Washing Element
1. If the element is coated with oil or soot,
wash in a solution of warm water and John
Deere R36757 Filter Element Cleaner or
its equivalent. Let the element soak at
least 15 minutes then agitate gently to
flush out dirt.
2. Rinse element thoroughly from inside with
clean water. Use element cleaning gun (A)
or free-running hose. Keep pressure low
to avoid damaging element.
3. Allow element to dry completely before
using. This usually takes from one to three
days. Do NOT oven dry or use drying
agents. Protect element from freezing until
dry.
4. Inspect element before installing.
gasoline or any solvent. Never us
compressed air on a wet element. Do
NOT oil element.
Primary element can be washed
up to six times.
To Next Page
Loading...