Unloading Conveyor 9960 Self-Propelled Peanut Combine
208 06/03/05 MAN091
Conveyor Troubleshooting
Conveyor Timing
After the conveyor is started, there is a five-
second delay before the two augers start
delivering material to the conveyor. The five-
second delay is factory set, but you can
change the amount of delay time as needed.
The relay panel contains a number of DIP
switches with corresponding time settings.
Activating the various DIP switches allows you
to lengthen or shorten the amount of time.
Make sure the engine is turned off and the
key is not in the ignition.
this function with the combine running.
Use a ladder or other suitable means to
reach this height.
function because material has collected
and is causing the conveyor to jam.
Pressing the reset buttons a couple of
times may dislodge the material and clear
out the problem.
To Next Page
Loading...