Storage 9960 Self-Propelled Peanut Combine
236 06/03/05 MAN091
Prepare the Combine
1. Clean the combine inside and out.
2. Cycle the feederhouse up and down
several times to prevent material buildup in
the concave area.
3. Repaint the areas needed.
4. Loosen all thrasher drive belts to avoid belt
stretch or damage.
5. Lubricate combine and grease adjusting
bolt threads.
6. Perform all 400 hour (yearly) service.
7. Fill the fuel tank to prevent condensation.
8. If combine is to be stored for a long period
of time, disconnect cables from batteries.
pressu
re washer spray directly on
bearings. High pressure water can get
past most seals and cause damage. Dry
these areas, then lube and drain combine.
It is not necessary to wax your
combine. However, if desired
clear wax that contains no abrasives
These types of waxes usually do not
contain cleaners.
To Next Page
Loading...