Amadas 9960 - Automatic Header Height Control

9960 Self-Propelled Peanut Combine Operator’s Station
MAN091 06/03/05 27
Header Engage/Header Reverse
To manually remove a “plug””
1. Bring the header engage and separator
engage switches to the “OFF” position.
2. Place the hydrostatic handle to
“NEUTRAL” and set the parking brake.
3. Turn the combine ignition switch to the
“OFF” position and remove the key.
Automatic Header Height Control
The Active Header Control™ (AHC) controls
the set point for Header Height Resume and
Header Height Sensing.
Refer to page 40 for information on using this
switch with Header Height Resume and
Header Height Sensing.
WARNING
NEVER manually remove a “plug” from the
combine header with the combine engine
running!
Serious injury or death may
occur.