Amadas 9960 - Page 241

9960 Self-Propelled Peanut Combine Maintenance
MAN091 06/03/05 231
SYMPTOM PROBLEM SOLUTION
Combine will not move
forward or reverse.
Relief valve open.
See your AMADAS/John Deere
dealer.
Transmission hard to
shift or will not shift.
Speed range control lever not in
neutral.
Move control lever to neutral.
Transmission shift linkage out of
adjustment.
Adjust transmission shift linkage.
Damaged, dirty, rusty, or pinched
shift cable.
Inspect, clean, adjust or replace
cable.
Internal transmission problem.
See your AMADAS/John Deere
dealer.
Ground travel speed
erratic.
Low oil.
Check for leaks and correct. Fill
reservoir.
Oil leak from lines.
Tighten line connections and
clamps or replace as needed.
Plugged filter. Change filter.
Exceeding maximum operating
pressure setting.
Shift to lower gear.
Speed control lever creeps
toward neutral.
See your AMADAS/John Deere
dealer.
System unable to keep charge
pressure.
See your AMADAS/John Deere
dealer.
Combine will not stop
when speed range
selector is in “N”
Neutral position.
Control cable out of adjustment. Adjust cable for neutral position.
Lack of power or lost
power. Combine not
responding to speed
range selector.
Low on oil.
Check for leaks and correct. Fill
reservior.
Plugged filter. Change filter.
Lack of charge flow or charge
pressure.
See your AMADAS/John Deere
dealer.
Leaking or broken oil line or
connection.
Check and repair as needed.