NOTE
Firmware upgrades can only be performed on the
following
GPS receivers:
SGR-1
AGI-3
AGI-4
1. In the setup menu, tap on "System" > "GPS" >
"Receiver".
2. Tap on "Firmware upgrade".
3. Confirm the update.
A warning is shown saying that the AMAPAD must
not be switched of
f.
4. Acknowledge the warning.
The firmware upgrade starts.
The AMAPAD will be restarted after the firmware
upgrade.
Using the ignition line
NOTE
This function is only available for the following GPS
receivers:
AGI-4
1. In the setup menu, tap on "System" > "GPS" >
"Receiver".
2. Tap on "Use ignition line".
005391
F | Configuring the AMAPAD | Entering the system settings
MG5574-EN-II | B.1 | 25.10.2016
53
To Next Page
Loading...
