3. Select the location.
NOTE
Recommended setting:
On the right
(two columns)
Defining the location of the working set key
With this setting, the location of the working set key on
the Universal
Terminal is defined. The working set keys
can be used to select the connected implements.
1. In the setup menu, tap on "System" > "ISOBUS">
"UT".
2. Tap on " Working set key location".
3. Select the location.
NOTE
Recommended setting:
up
3.6.2 Configuring the Task Controller
REQUIREMENTS
User access level has been set to "Standard" or
"Expert"; see page 41
Defining the TC version
The TC version is the software version for the ECU. The
dif
ferent TC versions support different forms of
documentation for job data.
005377
009193
048299
F | Configuring the AMAPAD | Entering the system settings
MG5574-EN-II | B.1 | 25.10.2016
65
To Next Page
Loading...
