AMX NetLinx Studio User Manual

Tools Menu Options
185
NetLinx Studio - Instruction Manual
Tools Menu Options
Overview
This section describes the options presented in the Tools menu. Note that the first two options in this menu (File
Transfers and Firmware Transfers are covered in the File Transfer Operations section on page 149:
See File Transfer Operations on page 149.
See Firmware Transfers on page 163.
Also, see the Working with Online Devices section on page 137 for details on using the Terminal Session and Telnet
Session options:
See Terminal and Telnet Sessions on page 145.
Reboot the Master Controller
Select Tools > Reboot the Master Controller to access the Reboot the Master Controller dialog. Use the options in this
dialog to reboot a specified master controller (FIG. 271).
The left side of this dialog lists the Projects and Systems that are included in the currently open Workspace. By default,
the currently active System is highlighted. The Master specified in the active (highlighted) System is the one that will be
rebooted.
1. Click on any other System to select a different Master to reboot.
2. Once the desired System has been selected (highlighted), click the Reboot button to reboot the Master associated
with the selected System.
All communications to the Master are stopped in order to activate a connection and initiate the reboot process.
Allow 20-30 seconds for the reboot.
You can reboot more than one Master before closing this dialog.
3. Click Done to close this dialog.
FIG. 271 Reboot the Master Controller dialog

AMX NetLinx Studio Specifications

General

Brand	AMX
Model	NetLinx Studio
Category	Software
Language	English