Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note
♦
Before disassembling suspension strut (coil spring), mark lo‐
cation from upper spring plate to coil spring -marking 1- and
from lower spacer to shock absorber -marking 2-.
♦
Without markings, the correct location around the imaginary
symmetrical axis will not be achieved! In that case, installation
of suspension strut (coil spring) is only possible after disas‐
sembling again.
WARNING
First pre-load spring far enough so that tension is relieved on
upper spring plate!
– Make sure that coil spring is seated correctly in Spring Support
- VAS6046/3- -arrow-.
– Pre-load coil spring until upper spring plate is free.
– Remove nut from piston rod.
– Remove components of suspension strut and coil spring using
Spring Tensioner - VAS6046- and Spring Support -
VAS6046/3- .
1 - Commercially Available Ratchet
2 - Shock Absorber Set - Retainer SW7 - T10001/14-
3 - Shock Absorber Set - Reversible Ratchet - T10001/11-
4 - Shock Absorber Set - Socket - T10001/3-
5 - Spring Tensioner - VAS6046-
6 - Spring Support - VAS6046/3-
7 - Press Piece - Multiple Use - VW455-
8 - -3350/2-
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
5. Coil Spring Suspension Strut and Crossmember 165
To Next Page
Loading...
