Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Pressing off
– Remove the drive axle, refer to
⇒ “7.3 Drive Axle, Bolted Inner Joint, Removing and Installing”,
page 182 .
– Remove brake caliper -1- and tie it with an wire -2- at brake
line bracket -3-.
– Remove brake disc.
– Remove screw -3- and Rear Speed Sensor -2-.
– Remove wiring harness from bracket -2-.
– Disengage parking brake cable at wheel bearing housing ⇒
Rep. Gr. 46 .
– Remove parking brake shoes ⇒ Rep. Gr. 46 .
– Install Bearing Installer - Wheel Hub/Bearing Kit - 1 -
T10205/1- with wheel bolts -A- onto wheel hub.
Wheel bolts -2- must not protrude on rear side of Bearing Installer
- Wheel Hub/Bearing Kit - 1 - T10205/1- .
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
6. Wheel Bearing Housing, Wheel Hub and Wheel Bearing 173
To Next Page
Loading...
