Audi Q7 2007 - 7.3 Drive Axle, Bolted Inner Joint, Removing and Installing

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Mount tools as depicted in illustration.
1 - Threaded Rod M20 - T10205/8-1-
2 - M20 Nut - T10205/8-2-
3 - Hydraulic Press - VAS6178-
4 - Bearing Installer - Wheel Hub/Bearing Kit - 1 - T10205/1-
5 - Bell - T10205/2-
6 - Threaded Rod M20 - T10205/8-1-
7 - M20 Nut - T10205/8-2-
8 - Thrust Piece - T10205/3-
– Remove wheel hub while counterholding Hydraulic Press -
VAS6178- .
– Remove circlip.
– Mount tools as depicted in illustration.
Note
Make sure that Pressure Piece - T10205/6- should faces toward
rear final drive.
1 - Threaded Rod M20 - T10205/8-1-
2 - M20 Nut - T10205/8-2-
3 - Hydraulic Press - VAS6178-
4 - Mount - T10205/4-
5 - Mounting tube - T10205/5-
6 - Threaded Rod M20 - T10205/8-1-
7 - M20 Nut - T10205/8-2-
8 - Thrust plate - T10205/6-
– Remove wheel bearing while counterholding Hydraulic Press
- VAS6178- .
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
174 Rep. Gr.42 - Rear Suspension