Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Enter the height value -A- between the ACC Adjustment De‐
vice - VAS 6430- contact patch and the wheel contact surface
as shown in the illustration and enter it in the alignment com‐
puter.
– Check the position of the calibration board on the calibration
beam and align it with the center of the board if necessary.
a = a
– Loosen the bolt -arrow- and place the measuring bar -1- on
the floor.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
7. Lane Assist 273
To Next Page
Loading...
