Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Adjust the calibration panel to the specified height -2- accord‐
ing to the alignment computer using the crank -1-.
If the specified height was reached-2-, then the measuring bar
must be pushed slightly forward and secured with the locking bolt.
Note
If in later procedure the height of the calibration board must be
corrected, make sure the measuring bar is touching the ground
when this is being done.
– Level the bubble level -A- using the adjusting screw -1-.
The bubble adjustment -A- serves to compare the ground condi‐
tions.
– Move the ACC Adjustment Device - VAS 6430- sideways
-arrow B- until the display on the alignment computer is within
the tolerance range.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
274 Rep. Gr.44 - Wheels, Tires, Wheel Alignment
To Next Page
Loading...
