Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Insert Subframe Support - T10031- in Engine/Gearbox Jack -
VAG1383A- .
– Place wood block -2- on Subframe Support - T10031- .
– Support rear subframe in lower control arm area -1-.
– Only remove rear screws from subframe.
– Lower the subframe with the Engine/Gearbox Jack -
VAG1383A- just far enough so that the Engine/Gearbox Jack
- VAG1383A- continues to support the subframe. Do not allow
subframe to hang freely.
– Remove steering gear from mounts.
– Slide steering gear to right side of vehicle
-direction of arrow 1-.
– Skirt Servotronic Solenoid Valve - N119- -1- around coolant
hoses -2- and rotate steering gear forward.
– Swing left tie rod downward.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
3. Steering Gear 297