Audi Q7 2007 - Page 351

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Power Steering Pump
❑ Allocation, refer to the
Parts Catalog.
❑ Fill with Hydraulic Oil
before installing
❑ Delivery Pressure,
Checking, refer to
⇒ “6.3 Power Steering
Pump Delivery Pres‐
sure, Checking”,
page 339 .
❑ Removing and Instal‐
ling, refer to
⇒ page 344 .
2 - Belt pulley
3 - Bolt
❑ 25 Nm
❑ Quantity: 3
4 - Bolt
❑ 25 Nm
5 - Bracket
6 - Bolt
❑ 25 Nm
7 - Banjo Bolt
❑ 35 Nm
8 - Seal
❑ Always replace.
9 - Pressure Line
❑ Note installed position,
refer to
⇒ Fig. ““Installation po‐
sition of intake hose and pressure line at vane pump”“ , page 344 .
10 - Intake Hose
❑ Note installation position on reservoir, refer to ⇒ “6.2 Lines and Hoses Overview”, page 338 .
❑ Note power steering pump location, refer to
⇒ Fig. ““Installation position of intake hose and pressure line at vane pump”“ , page 344 .
11 - Marking
❑ On intake hose.
❑ Marking on intake hose must align with marking on power steering pump.
12 - Spring Clamp
❑ Remove and install with Hose Clip Pliers - VAS5024A- .
13 - Marking
❑ On vane pump
❑ Marking on intake hose must align with marking on power steering pump.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
6. Power Steering Pump, Hydraulic Pipes and Reservoir 343