Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Installation position of intake hose and pressure line at vane pump
– Install intake hose -1- so that the marking -2- on it and marking
-3- on support -4- align.
Vane Pump, Removing and Installing:
Special tools and workshop equipment required
♦ Hose Clamps - Up To 25mm - 3094-
♦ Wrench - Pin Type - 3212-
♦ Torque Wrench 1331 5-50Nm - VAG1331-
♦ Used Oil Collection And Extraction Unit - SMN372500-
♦ Hose Clip Pliers - VAS5024A-
♦ Hydraulic Fluid
General Information
Vane pump is not designed to be serviced. If there are customer
complaints, the cause must be determined using a pressure and
leak test. If there is a malfunction, replace the vane pump.
♦ If fluid is low in reservoir, always check steering system for
leaks.
♦ If there are leaks in the area of the line connections, the lines/
connections must first be inspected for leaks, tightened as
necessary and wiped dry.
♦ Pump is delivered without oil. Therefore, Hydraulic Oil must be
filled before installation and turned by hand. Otherwise, noises
when driving or damage to pump may occur.
Removing
– With vehicles with air suspension, place vehicle on hoist, refer
to ⇒ “4 Positioning Vehicle on Hoist and Wheels”, page 10 .
– Only remove front noise insulation -1-.
– Extract hydraulic oil from reservoir using Used Oil Collection
And Extraction Unit - SMN372500- .
– Mark ribbed belt running direction
– Remove ribbed belt ⇒ Rep. Gr. 13 .
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
344 Rep. Gr.48 - Steering
To Next Page
Loading...
