Audi Q7 2007 - Page 357

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
❑ Clip lines from hydraulic oil cooler in bracket
19 - Bracket
❑ with washer and rivet
❑ for hydraulic oil cooler on condenser
❑ Insert hydraulic oil cooler in bracket
20 - Power-assisted steering gear
❑ Allocation, refer to the Parts Catalog.
21 - Cable tie with clip
❑ Replace the cable tie and install it at the same location.
22 - Bolt
❑ 9 Nm
23 - Pressure Line
❑ Tighten the union nut to 32 Nm.
❑ Note power steering pump location ⇒ page 357
❑ secure ⇒ page 350
24 - Banjo Bolt
❑ 35 Nm
25 - Seal
❑ Always replace.
26 - Power Steering Pump
❑ Allocation, refer to the Parts Catalog.
❑ Fill with Hydraulic Oil before installing
❑ Removing and Installing, refer to
⇒ “7.4 Power Steering Pump, Removing and Installing, Vehicles with V8 TDI Engine”, page 357 .
❑ Delivery Pressure, Checking, refer to
⇒ “7.3 Power Steering Pump Delivery Pressure, Checking, Vehicles with V8 TDI Engine”, page 352
27 - Seal
❑ Always replace.
28 - Bolt
❑ 9 Nm
❑ Quantity: 2
29 - Seal
❑ Always replace.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
7. Power Steering Pump, Hydraulic Pipes and Reservoir, Vehicles with V8 TDI Engine 349