Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Attach mounting elements from Scissor Lift Table - Audi Set -
VAS6131/10- at rear of subframe as shown in illustration.
– Rotate support element spindles upward enough so that all
mounting pins contact mounting points.
– Attach the support element base plates to the Scissor Lift Ta‐
ble - VAS6131- and tighten to 20 Nm.
– Disconnect left and right connectors -1- and -2-.
– Subframe, securing, refer to
⇒ “2.4 Subframe, Securing”, page 39 .
– Remove bolts -4-.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
28 Rep. Gr.40 - Front Suspension
To Next Page
Loading...
