Audi Q7 2007 - Page 380

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1 - Power Steering Pump
❑ Allocation, refer to the
Parts Catalog.
❑ Fill with Hydraulic Oil
before installing
❑ Delivery Pressure,
Checking, refer to
⇒ “8.3 Power Steering
Pump Delivery Pres‐
sure, Checking”,
page 368 .
❑ Removing and Instal‐
ling, refer to
⇒ page 373 .
2 - Bolt
❑ 85 Nm
❑ Transmission/engine/
power steering pump
bolt.
3 - Input Shaft
❑ If replacing the power
steering pump, replace
the input shaft as well.
❑ When re-installing, lu‐
bricate the drive shaft
splines and the vane
pump all the way
around. Allocation, refer
to the Parts Catalog.
4 - Seal
❑ Replace, refer to ⇒ Rep.
Gr. 15 .
5 - Radial Shaft Seal
❑ Replace, refer to ⇒ Rep.
Gr. 15 .
6 - Bolt
❑ 22 Nm
❑ Note the different lengths.
7 - Bolt
❑ 22 Nm
❑ Note the different lengths.
8 - Bolt
❑ 9 Nm
9 - Intake Line
10 - Seal
❑ Always replace.
11 - Bolt
❑ 9 Nm
12 - Pressure Line
❑ Note installed position, refer to ⇒ Fig. ““Pressure Line Location on Power Steering Pump”“ , page 373 .
13 - Bolt
❑ 9 Nm
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
372 Rep. Gr.48 - Steering