Audi Q7 2007 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Grease the splines on the power steering pump -1- and input
shaft -3- all the way around, refer to the Parts Catalog
– Replace the sealing ring -2-.
– Complete vane pump as shown in illustration and install on
engine.
1 - Power Steering Pump
2 - Seal
3 - When installing the input shaft, grease the splines on both
side all the way around. Allocation, refer to the Parts Cata‐
log.
– Install primary catalytic converter strap ⇒ Rep. Gr. 26 .
– Clean oiled places in engine compartment.
– Top off Hydraulic Oil .
– Check power steering fluid level, refer to
⇒ “4.1 Power Steering, Checking Hydraulic Oil Level”,
page 310 .
– Bleed steering system, refer to
⇒ “4.2 Steering System, Bleeding after Replacing”,
page 311 .
– Check the steering system for leaks, refer to
⇒ “4.3 Steering System, Checking for Leaks”, page 312 .
– On vehicles with air suspension, position vehicle on wheels,
refer to
⇒ “4 Positioning Vehicle on Hoist and Wheels”, page 10 .
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
8. Power Steering Pump, Hydraulic Pipes and Reservoir 377

Audi Q7 2007 Specifications

General

Brand	Audi
Model	Q7 2007
Category	Automobile
Language	English