Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– If the power steering pump -1- is replaced, the seal -2- and
input shaft -3- must also be replaced.
– Replace the power steering pump seal and o-ring -arrow- ⇒
Rep. Gr. 15 .
Installing
Install in reverse order of removal. Note the following:
Note
♦
Clean oiled places in engine compartment.
♦
Always replace O-rings on drive axle of vane pump and intake
line.
♦
Before installing new power steering pump on intake side, fill
hydraulic oil and screw in by hand until oil escapes on pressure
side.
♦
Hose connections and hoses must be free of oil and grease
before installing.
♦
Secure all hose connections with hose clamps appropriate to
the model, refer to the Parts Catalog.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
376 Rep. Gr.48 - Steering