Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Stabilizer Bar Bearing Location
– Install screws -4- through -1- and tighten.
– Install the cap -1- (if equipped) and the balance weight -2-.
Note
♦
Bonded rubber bushings can only be turned to a limited extent.
Only tighten suspension screws when vehicle is in curb weight
or control position.
♦
Wheel bearing, lifting to curb weight position on vehicles with
coil springs, refer to
⇒ “1.4 Wheel Bearing in Curb Weight, Lifting Vehicles with Coil
Spring”, page 12 .
♦
Wheel bearing, lifting to control position on vehicles with air
suspension, refer to
⇒ “1.5 Wheel Bearing in Control Position, Lifting Vehicles with
Air Suspension”, page 14 .
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
42 Rep. Gr.40 - Front Suspension
To Next Page
Loading...
