Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Wheel housing liner, removing, refer to ⇒ Rep. Gr. 66 .
– Clean air connection area.
– Remove connector piece -1- at residual pressure retaining
valve -2-.
Note
Residual pressure retaining valve must only be replaced if it was
damaged during Removing and Installing or servicing of suspen‐
sion strut (air suspension) or if air is not released from it anymore
(it sticks).
– Seal both connections. Make sure that no dust particles enter
connections.
– Remove nut -2- and disconnect connector -3-.
– Remove connector -2- from Left Front Dampening Adjustment
Valve - N336- and unclip electrical line.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
4. Air Suspension Strut, Upper Control Arm and Level Control System Sensor 61
To Next Page
Loading...
