Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Continuation for all
– Remove screws -1- to -3-.
– Turn the wheel hub until one of the holes for the wheel bolts
is on top.
– Install Engine/Gearbox Jack Adapter - Wheel Hub Support -
T10149- with wheel bolt on wheel hub.
– Support wheel bearing housing over Engine/Gearbox Jack
Adapter - Wheel Hub Support - T10149- with Engine/Gearbox
Jack - VAG1383A- .
WARNING
♦ Do not lift or lower vehicle with the engine/transmission
jack still under the vehicle.
♦ Do not leave Engine/Gearbox Jack - VAG1383A- below
vehicle any longer than necessary.
– Remove Tensioner Hooks (2 pc.) - VW552- .
– Remove nut from upper control arm and press arm off.
Audi Q7 2007 ➤
Suspension, Wheels, Steering - Edition 01.2014
4. Air Suspension Strut, Upper Control Arm and Level Control System Sensor 63
To Next Page
Loading...
