Barco Freya - Page 261

261R5910032 /00 Freya
2
5
6
1
3
4
Image 14–5
2. Click Manual (reference 1).
The network configuration parameters can now be edited.
3. Fill in the IP address (reference 2).
Tip: A network address contains 4 numbers with a value between 0 and 255, e.g.
192.168.1.101.
4. Fill in the Subnet mask (reference 3), e.g. 255.255.255.0.
5. Fill in the Default Gateway (reference 4), e.g. 192.168.1.1.
6. Click Save (reference 5) to activate.
New settings are now active.
or
click Discard button (reference 8) to cancel all changes.
The address 0.0.0.0 can not be used in any of the fields.
To avoid an internal IP address conflict with the ICMP, the projector’s IP address must be different
from 192.168.254.x .
Configuration - System access