82.3-0000010 OM
174
To simplify access to the two upper grease fittings of the pivot bearings, it is recom-
mended to dismantle both fenders of the front wheels with bases and bushings from the trac-
tor.
To dismantle the front wheel fender, it is required to remove post 5 (figure 5.4.27) to-
gether with fender 6 of front wheel 7 by unscrewing three bolts 4. Then remove base 3 and
bushings 1 by unscrewing four bolts 2.
After lubricating the bearings of the FDA pivot axles, install base 3 with bushings 1.
Bolts 2 must be tightened to a torque of 67 to 85 Nm. Then install posts 5 with fenders 6. Bolts
4 must be tightened with a torque of 40 to 50 Nm.
1 – bushing; 2 – bolt; 3 – base; 4 – bolt; 5 – fender post; 6 – fender; 7 – front wheel.
Figure 5.4.27 – Assembly and disassembly diagram of front wheel fenders
On the BELARUS-82.3 tractors of later releases, upper grease fittings 2 have side
outlets (figure 5.4.28). In this regard, the dismantling of the front wheel fenders to access
the two upper grease fittings of the pivot bearings is not required.
1 – wheel gear group; 2 – grease fitting; 3,4 – bearing; 5 – grease fitting; 6 – cap.
Figure 5.4.28 - Location of grease fittings for FDA pivot axle bearings on the BELA-
RUS-82.3 tractors of later releases
To Next Page
Loading...
