Branson 2000X - Page 133

2000X energy Power Supply Chapter 6: Operation
Instruction Manual Setting Other Weld Parameters
011-003-991 EN 6-41
Setting the Post Weld Seek
You can select Post Weld Seek. Post Weld Seek operates the stack at a low-level (5%)
amplitude immediately after the weld cycle afterburst, so the Power Supply can determine
the current operating frequency of the stack.
Take this action… To get this result…
Using the arrow keys, scroll downward
through the menu until you see Post Weld
Seek. Press the Select key that corre-
sponds to Post Weld Seek.
Use the same Select key to toggle between
Off and On.
Press Enter on the numeric keypad to save
the new value, or press Go Back/Esc to
make no change to the value.
WELD SETUP Pg7of13
Pretrigger> Off
Afterburst> Off
Post Weld Seek =Off
Select
Select
Select
WELD SETUP Pg7of13
Pretrigger> Off
Afterburst> Off
Post Weld Seek =On
Select
Select
Select
WELD SETUP Pg7of13
Pretrigger> Off
Afterburst> Off
Post Weld Seek =On
Enter