Energy Brake
Use this menu to turn Energy Braking On or Off. When Energy Brake is turned on, Energy Braking state will
be added to the weld sequence after Weld state and before Hold state. This gives the power supply some
time to reduce the amplitude before the sonics are shut off. Any overloads that occur will be ignored during
this state. They will be handled in the hold state. Weld cycle time will be increased by the time used by
Energy Braking.
Take this action… To get this result…
Using the arrow keys, scroll downward
through the menu until you see Energy
Brake. Press the Select key that corre-
sponds to Energy Brake. You can toggle
between On and Off.
When turned On, you use the ± keys to set
a time value between 0.010 and 1.000 sec-
ond.
To Next Page
Loading...
