Branson 2000X - Power Supply Manual and Guides; Actuator Manuals; Overview of These Models

Chapter 2: The 2000X energy Power Supply
Overview of these Models
2-2 011-003-991 EN
2.1.1 Power Supply Manual and Guides
The following documentation is available for the Branson 2000X Power Supply:
• 2000 X ea Instruction Manual (EDP 011-003-991-E)
• 2000 X ea Quick Start User’s Guide (EDP 100-214-281)
2.1.2 Actuator Manuals
The following documentation is available for the Branson Actuators compatible with this power supply:)
• 2000 X ae Actuator Instruction Manual (EDP 100-214-275) or
• 2000X Actuator Instruction Manual (EDP.Nr. 011-003-993-E)
2.2 Overview of these Models
The 2000X generates ultrasonic electrical energy through an ultrasonic converter for welding plastics. Sev-
eral models are available, depending on the desired frequency (for example, 20 kHz) or the desired power
range (for example, 2.5 kW). The Power Supply also contains a microprocessor-based controller module
that provides for control and monitoring of welding operations.
The Power Supply provides the following features:
• AutoTune with Memory (AT/M) — Allows the Power Supply to track and store the horn frequency of
the last weld.
• Auto Seek — Tracks and starts the horn on the correct frequency. It does this by running the horn at a
low-level amplitude (5%) to find and lock on to the horn operating frequency.
• Line Regulation — Maintains converter amplitude by regulating for variances in the line voltages.
• Load Regulation — Maintains converter amplitude over the full range of rated power.
• System Protection Monitor — Protects the Power Supply by providing five levels of protection.
1 Voltage
2 Current
3 Phase
4 Temperature
5 Power
• Select Start — Provides four starting ranges. Select Start in the Analog UPS allows the Power Supply
to ramp up amplitude at four different rates to accommodate different horn and load requirements. Select
Start in the Digital UPS allows Memory and Timed Seek to be turned on or off, and allows a range of time
values to be input for Ramp Time(s) and Seek Time(s).
• Frequency Offset — Provides for applying an external frequency offset to the operating frequency.