Chapter 6: Operation
Printing
6-68 011-003-991 EN
6.6 Printing
You can print information about the current welder setup, the most recent weld that you performed, or the
last 50 welds that you performed, as well as graphs of the power, amplitude, frequency of the most recent
weld, plotted against the time of the weld cycle (in seconds).
You can print on demand, sample and alarm, and mix any mode/trigger that is necessary to evaluate weld
results.
Settings for scale must be set for printing anything other than time mode (which is autoscaling).
You can gain access to the Print menu from any point in the menus by using the Print key, or from the Main
menu by selecting Print Menu. The following two pages contain a map of the menu options available on
the Print Menu. Procedures for printing follow the map.
Refer to Table 4.5 Printer Compatibility for a list of settings for that printer (This is not required if the printer
was purchased through Branson). For all other approved printers, consult the owners manual. For a list of
approved printers, refer to Table 4.5.
To Next Page
Loading...
