Chapter 6: Operation
Setting Primary Parameters
6-26 011-003-991 EN
6.3.6 Using Ground Detect Weld Mode
You can use Ground Detect Weld Mode to have ultrasonic energy turn off when the horn comes in contact
with your electrically isolated fixture or anvil. It is necessary to install Branson cable EDP No. 100-246-630
from the MPS/GDS receptacle on the rear of the actuator to your isolated fixture/anvil in order to utilize this
feature.
From within Ground Detect Mode, you can also select several other parameters, ranging from Hold Time
(in seconds) to Suspect and Reject Limits. The following two pages contain a map of the menu options in
Ground Detect Mode. Procedures for setting primary parameters follow the map. For more information on
setting the optional parameters within Ground Detect Mode, or any other welding mode, see Section 6.4:
Setting Other Weld Parameters, on page 6-30.
To Next Page
Loading...
