Branson 2000X - Using Time Weld Mode

Chapter 6: Operation
Setting Primary Parameters
6-14 011-003-991 EN
6.4.1 Using Time Weld Mode
You can use Time Mode to select the length of time that ultrasonic energy is applied to your parts. Within
Time Mode, you can also select several other parameters, ranging from Hold Time (in seconds) to Suspect
and Reject Limits. The following two pages contain a map of the menu options in Time Mode. Procedures
for setting primary parameters follow the map. For more information on setting the optional parameters
within Time Mode, or any other welding mode, see Section 6.4: Setting Other Weld Parameters, on page 6-
30.