Chapter 6: Operation
System Menus
6-8 011-003-991 EN
• AFTERBURST DELAY is shown only if you have set this parameter to ON, and indicates that the hold
step has ended but the afterburst has not begun.
• AFTERBURST is shown only if you have set this parameter to ON, and indicates that the afterburst of
ultrasonics is on during the up stroke.
• POST SEEKING is shown only if you have set this parameter to ON, and indicates that the Power Supply
is running a 5% amplitude cycle to find its operating frequency.
• RETRACTING indicates that the actuator is returning to the home position.
• PRINTING indicates the welder is not ready because the print buffer will not allow another cycle to start.
The following page contains a map of the menu options available from the Run Screen. Following the map
is a procedure to adjust the Weld Setup and view the weld results from the Run Screen.
To Next Page
Loading...
