Chapter 6: Operation
Setting Other Weld Parameters
6-30 011-003-991 EN
6.4 Setting Other Weld Parameters
From within each individual welding mode, you can also select several other parameters, including
Amplitude (%), Pretrigger, Afterburst, Post Weld Seek, Frequency Offset, Control Limits, Cycle Aborts, and
Suspect and Reject Limits. This section describes each of these parameters and the procedures for setting
them.
Press Enter on the numeric keypad to save
the new value, or press Go Back/Esc to
make no change to the value.
WELD SETUP Pg1of20
Weld Mode> Gnd Detect
Scrub Time(s)= 0.100
Hold Time(s)= 30.000
To Next Page
Loading...
