EasyManua.ls Logo

BRP Evinrude E-TEC G2 - Page 27

BRP Evinrude E-TEC G2
460 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
27
Routine Service
Maintenance
2
After the outboard shuts itself off, turn key switch
OFF, then detach garden hose.
IMPORTANT: When finished, leave the outboard
in vertical position long enough to completely drain
the powerhead.
Additional Recommendations
Top off oil reservoir.
Remove and inspect propeller.
Clean and grease propeller shaft.
Inspect outboard, steering system, and con-
trols. Replace all damaged and worn compo-
nents.
Touch up painted surfaces as needed. Coat
outer painted surfaces with automotive wax.
Remove battery(s) from boat. Store in a cool,
dry location. Periodically charge battery(s) while
stored. Refer to manufacturer’s maintenance
recommendations when servicing batteries.
Store outboard in upright (vertical) position.
Check for fuel leakage.
ICON Touch 7.0 CTS
1. Menu/Settings
2. Winterize Tab
356596-36
ICON 3.5C
1. Mode Select
216762-12
ICON Pro 5 inch Digital Gauge
1. Mode button
008686
1
2
1
1
I-Command 3.5 inch Digital Gauge
1. Menu button
008191
WARNING
Failure to check for fuel leakage could allow a
leak to go undetected, resulting in fire or
explosion.
1

Table of Contents

Other manuals for BRP Evinrude E-TEC G2

Related product manuals